- Home
- Brands
- Mercedes-Benz
- Brake repair
Mercedes-Benz Brake Repair in Dubai
Pads, discs, brake fluid, sensors and electronic parking brake for Mercedes-Benz at our DIP 2 workshop.
Overview
We replace Mercedes-Benz brake pads, discs and wear sensors, renew brake fluid and service electronic parking brakes. On Mercedes models the pads and discs are designed to wear together, so we measure both and tell you exactly what is needed.
- LocationWarehouse 44, DIP 2
- OpenMon–Sat, 9 AM–10 PM
- Phone058 821 2219
- PickupFree over AED 1,500
Common jobs
What we see on Mercedes cars
Pads, discs and wear sensors
The pad-wear warning comes from a sensor that is replaced with the pads. We measure disc thickness against the minimum stamped on the disc.
Brake fluid every two years
Mercedes specifies brake fluid replacement at Service B or every two years, because fluid absorbs water and loses performance in heat.
Electronic parking brake
Newer models need diagnostic software to open the rear calipers in service mode before pads are changed.
Vibration under braking
Steering-wheel shake when braking usually means uneven discs, but worn front suspension parts can feel similar. We check both.
Signs to watch for
- Squealing or grinding when braking
- Brake warning or pad-wear light on the dashboard
- Vibration through the steering wheel or pedal when braking
- Soft or spongy brake pedal
- Car pulls to one side under braking
- Longer stopping distances than usual
How we do it
Inspect
We measure pad thickness and disc condition and check fluid, hoses and calipers.
Advise
You get a clear report: what is worn, what can wait and what must be done for safety.
Replace
Pads, discs or fluid are replaced and components are cleaned and lubricated.
Road test
We bed in the new pads and road-test to confirm smooth, straight braking.
FAQ
Common questions
Do I need new discs with every Mercedes pad change?
Not always, but often. If the discs are close to minimum thickness, new pads alone will not last.
Can you reset the brake warning light?
Yes. Once the pads and sensor are replaced, the warning clears and we confirm there are no stored brake faults.